Equipment process

1. Pulping system

(1) The raw materials are put into the pulping machine, and a proper amount of water is added. After a long time of stirring, the waste paper is turned into pulp and then put into the pulp storage tank for storage.

(2) The pulp in the storage tank is put into the mixing tank, and the pulp concentration is adjusted in the mixing tank. The white water in the return tank and the concentrated pulp in the storage tank are further stirred by the homogenizer.After the pulp is adjusted into suitable pulp, it is put into the pulp supply tank for use in the forming system.

Equipment used: pulping machine, homogenizer, pulp pump, vibrating screen, pulp distributor.

2. Forming system

(1) The pulp in the pulp supply tank is fed into the molding machine and absorbed by the vacuum system. The pulp is left on the mold through the mold on the equipment to form. The white water is absorbed and driven back to the water tank by the vacuum pump.

(2) After the mold is adsorbed, the transfer mold will blow the formed products from the forming mold to the rotating mold through the positive pressure air outlet of the air compressor, and some products will be sent out by the transfer mold.

Equipment: molding machine, mold, vacuum pump, negative pressure tank, pump, air compressor, mold cleaning machine.

3. drying system

(1) Natural drying method: drying products directly by weather and natural wind.

(2) Traditional drying: brick tunnel kiln, heat source can choose natural gas, diesel, coal, dry firewood

LPG and other heat sources.

(3) New multi-layer drying line: the 6-layer metal drying line can save more than 30% energy than the drive drying line, and the main heat sources are natural gas, diesel oil, liquefied petroleum gas, methanol and other clean energy.

4. Auxiliary packaging of finished products

(1) Automatic stacker

(2) Baler

(3) Transfer conveyor